<rss version="2.0"><channel><title>PMI.gr Guestbook</title><item><title><![CDATA[5/15/2010 webmst@libero.it]]></title><link><![CDATA[http://www.pmi.gr:80/pmi.gr/Default.aspx?pg=d0a3b369-20d6-4fb5-8f52-10d3e611d449#c59f5726-051c-4629-858c-8f23d5ffc37b]]></link><description><![CDATA[Dear Michael,

I've tried your antenna alignment software, using it some DWL-2100AP units running original DLINK firmware 2.50eu.

I've experienced some problems, such as:

- signals reported on middle-left ("client" side) is not extracted correctly from the "get status" output, as the program displays "receive signal " and "ack signal" instead of their numeric values;

- client rate reported on top-left is not reported after the MAC address (it still shows "Client rate")

- the graph shows just one couple of data, the  "access point" data, while "client" data is not shown

- sometimes, "access point" data logging (lower box) stops working and the program aborts (I think this is due to a problem in sending/parsing the commands/responses that generates runtime errors)

- sometimes, the "stop checking" button does not work, so you have to terminate the program via the task manager

- the program form is still resizable dragging the lower right corner with the mouse (set the VB form property to disable it)

Then, I would suggest the following improvements:

- last used IP addresses and password to be stored, so the are quickly recalled next time when the program is run

- password characters converted in "*", one after the other, as they are typed, to preserve security

I hope you appreciate my suggestions.

Best regards,

Alberto Mensi
Alessandria, Italy]]></description></item></channel></rss>